Thingiverse
6mm Wing Nut
von BM3D
10
Downloads
8
Likes
0
Makes
UPDATED-First file was a very tight fit for nuts,this works alot better while still being a snug fit.
6mm Wing Nut made up of printed parts and two M6 nuts.I use it for my Drum-Kit symbols.
I printed on a Reprap Prusa i2 using PLA .3mm Layer height,60% infill.
Print part out,insert M6 Nut into space,glue in place.
6mm Wing Nut made up of printed parts and two M6 nuts.I use it for my Drum-Kit symbols.
I printed on a Reprap Prusa i2 using PLA .3mm Layer height,60% infill.
Print part out,insert M6 Nut into space,glue in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!