MakerWorld
7 Can Caddy
von isaacramens
8
Downloads
5
Likes
0
Makes
A perfect caddy for carrying 7 cans at a time. Barely larger than a single can but holds 7 securely. 1 can in the middle and the other six just clip in around the sides. Assembly Start by sliding on each of the 6 clips to the base. Once all 6 are on, then add the top ring by sliding it down, being careful to make sure that all tabs are lined up and slowly just work your way around until it is full set. it can be a little tricky but that's what makes it strong and secure. Then take the handle and simply feed it through until it clips. To access the can in the middle, just lift the end of of the strap over the clip and push it back through. Also check out my bike mount using the same mechanism!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
