Thingiverse
7" LCD Display Case
di pteppic
1
Download
2
Likes
0
Makes
A case for a 7" LCD display (destined for the trashcan) with a cheap (chinese) controller board.
This started as a test whether the board actually worked with this type of display, and additionally if i could fit all parts in a minimal case.
The case works quite well, the display is just push-fit into place and fixed into place with the controller base-plate. Finally everything is squished into place by the back-plate.
If you should decide to print this, you'll need 4x M2.5x8 (case), 1x M2.5x6 (controller) button-heads and 6x M3x6 (PCBs) countersunk screws.
This started as a test whether the board actually worked with this type of display, and additionally if i could fit all parts in a minimal case.
The case works quite well, the display is just push-fit into place and fixed into place with the controller base-plate. Finally everything is squished into place by the back-plate.
If you should decide to print this, you'll need 4x M2.5x8 (case), 1x M2.5x6 (controller) button-heads and 6x M3x6 (PCBs) countersunk screws.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
