7 Point Star

This model is a star I created for a hanging light. If you want to create a star that has a light, then you will need resize the raw parts (excluding the clip part) by 280% to create a 20 inch star. Directions: Step 1:Print 7 pieces of “IKStar - Print 12 resize 280% ”. Resize the part by 280% to create a 20 inch that will accept a light, or print at 100% to create a smaller star. Assemble with a small amount of glue and clip one piece into the other to create half of 7 pointed star. I found it easiest to have the star lay on a flat surface while drying to ensure the bottom pieces are flush with the table. Step 2:Repeat Step 1, if making a star with out a light. If printing at 280% for a light print 5 pieces of “IKStar - Print 12 resize 280%” and 2 pieces of IKStar - Print2 resize 280. Assemble 6 pieces with 1 so that missing point does not have a clip end. Step 3:Glue top and bottom together to create star with one “open” point.For star without a light, glue to and bottom together to c