7" SourceOne GoPro Mount (20°)
by FPV-SE
30
Downloads
29
Likes
0
Makes
This is a GoPro mount for the SourceOne with 7 inch arms and props offering the following…
20° GoPro 5/6/7 with ND filter. No props in shot.
HS1177 (Full) 26x28mm ( to fit Runcam Swift 2 Rotor Riot Edition)
Full length top deck battery (Approximately 155mm)
Optional Matek SAM-M8Q GPS and ViFly Finder v2 mount.
TO AVOID DISAPPOINTMENT PLEASE READ THE FOLLOWING CAREFULLY!
For proper fitment I have extended the arms forward by one hole. The stack screws now do not go through the arms. I have added new screws and used nuts to secure the inside facing mounting holes of the arms. Please see pictures. Note that this will increase the likelihood of you breaking something in a crash, but gives much better prop clearance. Your motor cables may also be too short for this. You may be able to fit the mount without extending the arms but will likely need to trim a slot on the mount to the left and right for the prop. The props will be VERY close to the GoPro if it even fits at all. If y
20° GoPro 5/6/7 with ND filter. No props in shot.
HS1177 (Full) 26x28mm ( to fit Runcam Swift 2 Rotor Riot Edition)
Full length top deck battery (Approximately 155mm)
Optional Matek SAM-M8Q GPS and ViFly Finder v2 mount.
TO AVOID DISAPPOINTMENT PLEASE READ THE FOLLOWING CAREFULLY!
For proper fitment I have extended the arms forward by one hole. The stack screws now do not go through the arms. I have added new screws and used nuts to secure the inside facing mounting holes of the arms. Please see pictures. Note that this will increase the likelihood of you breaking something in a crash, but gives much better prop clearance. Your motor cables may also be too short for this. You may be able to fit the mount without extending the arms but will likely need to trim a slot on the mount to the left and right for the prop. The props will be VERY close to the GoPro if it even fits at all. If y
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!