Thingiverse
WIP: Radial fan 72 mm (Ultimaker electronics replacement)
by jonnor
23
Downloads
23
Likes
0
Makes
Designed for using the hub (36 mm) from a 80 mm axial
fan as the motor, and as a replacement for the
electronics fan on the Ultimaker
WORK IN PROGRESS:
* Blades are complete, have been printed & tested for fit.
* Shroud lid and screw mounts still missing.
Tip: the blades are designed to be 2 x 0.4mm nozzle widths wide. If your slicer puts infill in the blades, tune the nozzle size setting a bit up (I used Cura, had to use 0.45mm). This will drastically reduce print time.
fan as the motor, and as a replacement for the
electronics fan on the Ultimaker
WORK IN PROGRESS:
* Blades are complete, have been printed & tested for fit.
* Shroud lid and screw mounts still missing.
Tip: the blades are designed to be 2 x 0.4mm nozzle widths wide. If your slicer puts infill in the blades, tune the nozzle size setting a bit up (I used Cura, had to use 0.45mm). This will drastically reduce print time.
Sign in to leave a comment
Sign in