Thingiverse
Spool Holder For Printrbot Metal Plus
by gueha
27
Downloads
11
Likes
1
Makes
This spool holder fits on top of a printrbot metal plus.
It consists of two plates which hold the bearings and 4 coverings to prevent the aluminium tube from sliping out of the bearings.
The design was made with DesignSpark Mechanical 2.0.
Construction files are attached for further development.
In addition to the printed parts following is needed:
- 4 bearings 8x22x7mm (inner diameter x outer diameter x width) - I used some with the name 608 ZZ.
- 2 aluminium tubes 8mm outer diame
It consists of two plates which hold the bearings and 4 coverings to prevent the aluminium tube from sliping out of the bearings.
The design was made with DesignSpark Mechanical 2.0.
Construction files are attached for further development.
In addition to the printed parts following is needed:
- 4 bearings 8x22x7mm (inner diameter x outer diameter x width) - I used some with the name 608 ZZ.
- 2 aluminium tubes 8mm outer diame
Sign in to leave a comment
Sign in