Thingiverse
Printrbot Simple Metal GT2 Belt Clip
by 3DMasterRace
165
Downloads
93
Likes
1
Makes
Simple Belt Clip
Noticed that the default cable tie method, as per instructions leads to slippage in belt tension over time...
Top Tip...
The screw that holds the belt in the hole at the extruder end of the Y axis in the instructions (Step 24). Is not long enough (M3 10mm), put a longer one in to avoid the belt pulling it at and angle. then when fitting the Y arm just use a shorter screw on the opposite side or just miss it out...
Reference:
http://help.printrbot.com/Guide/P
Noticed that the default cable tie method, as per instructions leads to slippage in belt tension over time...
Top Tip...
The screw that holds the belt in the hole at the extruder end of the Y axis in the instructions (Step 24). Is not long enough (M3 10mm), put a longer one in to avoid the belt pulling it at and angle. then when fitting the Y arm just use a shorter screw on the opposite side or just miss it out...
Reference:
http://help.printrbot.com/Guide/P
Sign in to leave a comment
Sign in