Thingiverse
Craftbot dial indicator mount
by Kezat
41
Downloads
29
Likes
1
Makes
Simple mount for a dial indicator to check that the bed is level and if it is warped or not.
Held in place just by gravity and a V-grove to key on to the front gantry rod.
9.5mm hole for the dial indicator.
Good for 40 to 50mm rod spacing
Carefull not to push down on the dial as your taking a reading as the gantry rods will bend slightly at the slightest pressure throwing off the reading.
If printed in ABS it should have a good friction fit for the 9.5mm shank of a dial indica
Held in place just by gravity and a V-grove to key on to the front gantry rod.
9.5mm hole for the dial indicator.
Good for 40 to 50mm rod spacing
Carefull not to push down on the dial as your taking a reading as the gantry rods will bend slightly at the slightest pressure throwing off the reading.
If printed in ABS it should have a good friction fit for the 9.5mm shank of a dial indica
Sign in to leave a comment
Sign in