Simple top hinged front cover for enclosure on Replictor

This thing is a laser cut 3mm Acrylic front door for a Makerbot Replicator. It uses Hinges (http://www.thingiverse.com/thing:757329) and attached to the Case without any new holes or other modifications. Hinges have a simple removable 3mm hinge pin, and install with existing holes in the case.

Hinges attach to the Acrylic panel with M3 screws and these printable stress relieving washers (http://www.thingiverse.com/thing:755320).

This simple design lets gravity do the work of holding i