Thingiverse
SparkFun RFID USB Reader mounting plate and drilling guide
by ctheroux
5
Downloads
9
Likes
0
Makes
This thing contains a mounting plate and a drilling guide for the "SparkFun RFID USB Reader" (SEN-09963).
The base plate is one mm thick. M2 5 mm or 1/4" 4-40 screws are needed to fasten the board to the mounting plate. The mounting holes are three mm in diameter.
The holes do not go through the lower layer to make it easier to print. You will have to drill them.
This thing is a complement to http://www.thingiverse.com/thing:328552 .
The base plate is one mm thick. M2 5 mm or 1/4" 4-40 screws are needed to fasten the board to the mounting plate. The mounting holes are three mm in diameter.
The holes do not go through the lower layer to make it easier to print. You will have to drill them.
This thing is a complement to http://www.thingiverse.com/thing:328552 .
Sign in to leave a comment
Sign in