Thingiverse
Microwave foot
by mohissa1987
10
Downloads
11
Likes
0
Makes
One of my microwave's feet disappeared, so I made this one. This will snap into the hole.
The hole on my microwave is around 7.84mm.
The height of the foot is 18.3mm.
the width starts at around 19.9mm down to 18.2mm.
hope this helps!
It will need support material. Before printing it, i thought it will be easy to remove the support material. But I couldnt remove it after printing. Nonetheless, it snapped in with no problems.
The hole on my microwave is around 7.84mm.
The height of the foot is 18.3mm.
the width starts at around 19.9mm down to 18.2mm.
hope this helps!
It will need support material. Before printing it, i thought it will be easy to remove the support material. But I couldnt remove it after printing. Nonetheless, it snapped in with no problems.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in