Thingiverse
Mendel90 spool holder (customizable)
19
Downloads
16
Likes
0
Makes
Yet another Mendel90 spool holder. I designed this because I had a piece of 10mm round steel lying about and I wanted a pair of brackets in which it would snap-fit.
The snap-fit works fine and the bracket seems sturdy enough. I have noticed, though, that the back plates of the printer are quite flexible. This might be a problem: if you bend the plates outward far enough, the rod cal fall out. I don't think this will be a problem in daily operations, but I'll have to keep an eye on it.
**Up
The snap-fit works fine and the bracket seems sturdy enough. I have noticed, though, that the back plates of the printer are quite flexible. This might be a problem: if you bend the plates outward far enough, the rod cal fall out. I don't think this will be a problem in daily operations, but I'll have to keep an eye on it.
**Up
Sign in to leave a comment
Sign in