Thingiverse
DaVinci 1.0 50mm fan Clip-On Front Duct with Support
by Boogiemann
27
Downloads
12
Likes
0
Makes
Could not create a clean print from the original part with supports created by Slic3r. I simply added manual supports to the upper clips to print the part without additional supports.
I have since created a new duct. It works much better than this one.
http://www.thingiverse.com/thing:824926
I have since created a new duct. It works much better than this one.
http://www.thingiverse.com/thing:824926
Sign in to leave a comment
Sign in