Thingiverse
7IP-CAPLCD 7" Case
door KarlMowbray
4
Downloads
4
Likes
0
Makes
I bought an touchscreen LCD. There is no external shell on this device so I made one.
Its fairly basic but does the job (so far)
This is the item I purchased.
amazon.co.uk/gp/product/B08YZ8XSG9/
The design uses print in place buttons just because I wanted no fiddly bits or have to wait for new parts. I will run these a while and see if I need to do something different, hence the WIP status of this design.
I have not tested the bolt fixings yet (bolts on order) I will adjust and repost if changes need to be made.
The photo of by print has a 1mm gap on the right hand side. I have adjusted this in the code and will make a new print once I have validated the bolt positioning.
As always, feel free to steal, use, suggest changes.
Its fairly basic but does the job (so far)
This is the item I purchased.
amazon.co.uk/gp/product/B08YZ8XSG9/
The design uses print in place buttons just because I wanted no fiddly bits or have to wait for new parts. I will run these a while and see if I need to do something different, hence the WIP status of this design.
I have not tested the bolt fixings yet (bolts on order) I will adjust and repost if changes need to be made.
The photo of by print has a 1mm gap on the right hand side. I have adjusted this in the code and will make a new print once I have validated the bolt positioning.
As always, feel free to steal, use, suggest changes.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!