Thingiverse
7x Dice Holder
door Iceteavanill
58
Downloads
36
Likes
0
Makes
Simple Dice holder for keeping the dice together.
Requires :
- 2 x M3 * 20 Screwes
- 4 x M3 Nuts ( 2 are also posible )
- 4 x M3 Washers ( optional )
- 6 x 6mm * 2mm Neodymium magnets
- and a dab of loctite (optional )
Only thing to watch out for is that you place the magnets the correct side up so they attract each other.
I glued the magnets in the space with 2 component adhesive.
Assemble the hinges like shown in the picture. The screws should not squeeze the hinge!
Have Fun ;)
Requires :
- 2 x M3 * 20 Screwes
- 4 x M3 Nuts ( 2 are also posible )
- 4 x M3 Washers ( optional )
- 6 x 6mm * 2mm Neodymium magnets
- and a dab of loctite (optional )
Only thing to watch out for is that you place the magnets the correct side up so they attract each other.
I glued the magnets in the space with 2 component adhesive.
Assemble the hinges like shown in the picture. The screws should not squeeze the hinge!
Have Fun ;)
Iceteavanill publiceert ook op
5 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
