8/16 port Keystone patch panel

A simple keystone 'patch panel' for my home lab. I needed a patch panel for a few HDMI connections as I was tired of opening up the rear of my rack every time I needed to connect a different host up to my monitor.

The model is tailored to my specific rack, but should be easily adoptable to any other dimensions. Import the Fusion360 model and then edit the first sketch in the timeline as needed and adjust the `pattern on line` step to adjust the number of keystone jacks.

As is, the model has:

- `178.5mm` from 'edge' to 'edge' between the two screw holes
- `6.5mm` diameter for the holes as my rack uses M6 screws.

If those dimensions do not work for you, you can just glue the print down as needed.


Note: After printing the model you see in the pictures below, I added a small cutout which should make it easier to depress the clip on the 'male' end of a keystone device from the 'user facing' side as you'd typically find on a proper patch panel

Additional details on my si