8 Bay SSD Tower

A simple tower that supports 2.5" SATA SSD's. Specs of each “bay”:8mm height71.3mm wide87mm depthAll walls are 2mm thick4mm screw holes(SSD's use 3mm)Recommended Hardware:M3x5mm minimum(you may be able to get away with 4mm)SATA power splitter or connectors that have their cable go straight out. Bays are so close so clearance is not possible for most SATA power connectorsRecommended Print Options:Print standing up, no tree supports neededPrint WITH outer brims (Others → Bed Adhesion → Brim Type → Outer brim only)AND/ORTurn off internal fansIf you print without brims then the print may warp upward from cooling too quickly. Even when printed inside an enclosure. When putting drives in and screwing them in, you will want to screw at each corner a little at each time. Too tight at one corner will “pull” the drive to that corner and then the other screw holes will be off-center. I have a mini-NAS I am building and I only want/need SATA SSD's, but I could not find a suitable m