Slicer Discord
8 Card Wallet – 3D-Druckmodell von Thingiverse Thingiverse

8 Card Wallet

152 Downloads
118 Likes
0 Makes
Zum Modell
This is a wallet with a money clip, and a slot for a [USB flash drive] [1].

Other than the obvious wallet-y features, the design goals here were:
- Cover the cards as much as possible, to avoid damaging their edges
- Hold a USB drive, to let me remove the one I was carrying on my keychain
- Avoid sharp edges, which were apparently abrading holes in my pockets

Known flaws, after carrying it around for a bit:
- The money clip's clearance against the wallet body is too loose, single bills don't clip well
- The money clip spline's nearest point to the wallet body is too far out, folded US currency doesn't sit flush against the spine while under the clip
- The radiuses along the edges of the piece create a thin wall that eventually split. I'll redesign this and address this issue in the next version.

[1]: https://www.sandisk.com/home/usb-flash/ultra-flair "SanDisk Ultra Flair USB Flash Drive"
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
50 mm (Klein)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

1 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen