Thingiverse
8" Knife Cover
by guitarist809
6
Downloads
5
Likes
0
Makes
Covers an 8" knife. Has slots to allow moisture to dry if not totally dry when putting away.
Use a 0.4mm nozzle. PETG or something other than PLA recommended (since PLA is so brittle). 0.1mm layer height.
No supports needed, print on the thinner edge. I didn't use a brim but it may be necessary if you don't have enough adhesion.
Use a 0.4mm nozzle. PETG or something other than PLA recommended (since PLA is so brittle). 0.1mm layer height.
No supports needed, print on the thinner edge. I didn't use a brim but it may be necessary if you don't have enough adhesion.
guitarist809 also publishes on
6 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
