Thingiverse
8 Speed plus Reverse H pattern shifter for sim racing
por KUZTM_3D
3
Descargas
7
Likes
0
Makes
8 speed plus reverse H shifter with 2 push buttons
Requires
2x 10mm springs 50mm long
4x 12x4 round magnets
4x 10x3 round magnets
2x 6700zz bearings
300mm 16mm aluminium tube
9x micro switches
2x square push button switches
Raspberry Pi Pico
Assorted M3 Nuts and bolts*
*I used M3x30 and cut to length
No mounting solution is included due to the massive amount of different sim setups. Outer case has allowance for a clamp to be attached with M3 hardware. Mounting hole spacing is 50x50mm
This model will receive no updates, instructions or configured firmware. These items as well as other cosmetic stl files are available in the version available on cults3d
https://cults3d.com/en/3d-model/gadget/8-speed-plus-reverse-h-shifer-with-2-buttons
Requires
2x 10mm springs 50mm long
4x 12x4 round magnets
4x 10x3 round magnets
2x 6700zz bearings
300mm 16mm aluminium tube
9x micro switches
2x square push button switches
Raspberry Pi Pico
Assorted M3 Nuts and bolts*
*I used M3x30 and cut to length
No mounting solution is included due to the massive amount of different sim setups. Outer case has allowance for a clamp to be attached with M3 hardware. Mounting hole spacing is 50x50mm
This model will receive no updates, instructions or configured firmware. These items as well as other cosmetic stl files are available in the version available on cults3d
https://cults3d.com/en/3d-model/gadget/8-speed-plus-reverse-h-shifer-with-2-buttons
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
