Thingiverse
#8 (US) Crochet Hook (No Support Needed)
by rdahm
4
Downloads
6
Likes
0
Makes
This is a remix of http://www.thingiverse.com/thing:53854
I had used the customizer to build these to US #8 size but went to print and noticed the original output had two thumb rests, which required support. Took the bottom one out so they should build cleanly with no support... Doing a test print now.
Created with Customizer, then altered in Rhino
http://www.thingiverse.com/apps/customizer/run?thing_id=53854
I had used the customizer to build these to US #8 size but went to print and noticed the original output had two thumb rests, which required support. Took the bottom one out so they should build cleanly with no support... Doing a test print now.
Created with Customizer, then altered in Rhino
http://www.thingiverse.com/apps/customizer/run?thing_id=53854
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
