Thingiverse
XYZ Da Vinci 1.0 Three fan extruder carriage.
by firecardenal
69
Downloads
61
Likes
0
Makes
I am working on a new extruder for my Da Vinci 1.0.
based on the Budas extruder desing for 1.75mm. (my version).
The two front fans blows air directly to the heat-sink but the third works as extractor fan, evacuating hot air from the chamber and taking it through an internal duct in the carriage to the printing area.
This version is for a 15mm. linear bearings.
The three sides clear covers(between the fans) give hi efficiency to air flow system.
The direct drive is an adaptation
based on the Budas extruder desing for 1.75mm. (my version).
The two front fans blows air directly to the heat-sink but the third works as extractor fan, evacuating hot air from the chamber and taking it through an internal duct in the carriage to the printing area.
This version is for a 15mm. linear bearings.
The three sides clear covers(between the fans) give hi efficiency to air flow system.
The direct drive is an adaptation
Sign in to leave a comment
Sign in