Thingiverse
Spool support for smartrapcore
by Lyscanthrope
17
Downloads
17
Likes
1
Makes
This is a simple spool support for the smartrapcore.
It work for small spool (tested for up to 750gr but I think it'll work for 1kg).
Just hang on the top of teh smarrapcore. I hanged mine on the right side of it (as I have my extruder outside) and I use a small clip to guide the filament.
Picture of the setup to follow.
All improvement are welcome.
It work for small spool (tested for up to 750gr but I think it'll work for 1kg).
Just hang on the top of teh smarrapcore. I hanged mine on the right side of it (as I have my extruder outside) and I use a small clip to guide the filament.
Picture of the setup to follow.
All improvement are welcome.
Sign in to leave a comment
Sign in