Thingiverse
Simple Bowden E3DV6 hot end carriage
by mmutch
5
Downloads
4
Likes
0
Makes
A simple Bowden style extruder X carriage mount for a E3DV6
NOTE:
On this design the baring shafts (8mm with LM8UU bearings) are in line (vertical) with the drive belt.
To affix the belt to the unit use a spare strip of drive belt of about 40mm glued into the slot provided on the back then press the drive belt lining up the teeth.
NOTE:
On this design the baring shafts (8mm with LM8UU bearings) are in line (vertical) with the drive belt.
To affix the belt to the unit use a spare strip of drive belt of about 40mm glued into the slot provided on the back then press the drive belt lining up the teeth.
Sign in to leave a comment
Sign in