Thingiverse
Fitbit / Watch Stand
by Bixler13
15
Downloads
13
Likes
0
Makes
Print two rod holders and don't forget to MIRROR one!
Print WITH supports for the ends of the butterfly wings.
The rods are 5/16in in diameter. Cut the rods to length and use a hammer to press them into the holes. No glue should be required.
Printed on Printrbot simple
.25mm layer thickness
15% infill
If you want a two tone effect just pause the print and switch your filament.
Print WITH supports for the ends of the butterfly wings.
The rods are 5/16in in diameter. Cut the rods to length and use a hammer to press them into the holes. No glue should be required.
Printed on Printrbot simple
.25mm layer thickness
15% infill
If you want a two tone effect just pause the print and switch your filament.
Sign in to leave a comment
Sign in