Thingiverse
Bukito 20mm PLA Cooling Fan Duct
by codemite
10
Downloads
10
Likes
0
Makes
This is an alternative cooling fan duct design to the Bukito version released by Deezmaker:
http://www.bukobot.com/bukito-pla-cooling-fan-duct
I used the Deezemaker version for a while but found that I occasionally had some issues of the fan duct hitting the screws on the print bed if the print job extended towards the Left side (fan side). As well, I could only see the nozzle from the right side when adjusting the bed height.
I made this new version to put it towards the front o
http://www.bukobot.com/bukito-pla-cooling-fan-duct
I used the Deezemaker version for a while but found that I occasionally had some issues of the fan duct hitting the screws on the print bed if the print job extended towards the Left side (fan side). As well, I could only see the nozzle from the right side when adjusting the bed height.
I made this new version to put it towards the front o
Sign in to leave a comment
Sign in