Thingiverse
Duplicator I3 Controlbox Cover for LCD v2.0
by TiDiPi
145
Downloads
76
Likes
7
Makes
The Second attempt at modding a Front angled cover for the duplicator I3's control box.
This time, I added :
- 40mm fan on the bottom side (would work best if back cover uses a fan extracting air too) Recommended screws would be 4 x M3x15.
- Front button for emergency stopping and better gap between the original wheel and the print.(no springs or anything required)
The one in the pictures follows this config : PLA @195°C, 0.3 layers with 30% infill and 50mm/s speed (+ activate support)
This time, I added :
- 40mm fan on the bottom side (would work best if back cover uses a fan extracting air too) Recommended screws would be 4 x M3x15.
- Front button for emergency stopping and better gap between the original wheel and the print.(no springs or anything required)
The one in the pictures follows this config : PLA @195°C, 0.3 layers with 30% infill and 50mm/s speed (+ activate support)
Sign in to leave a comment
Sign in