88mm Brushed Toothpick Frame

This is a toothpick quad with 8.5mm motors and 55mm props. Its made to house a whoop sized FC (26 x 26mm).
The battery holder needs to be mounted with the opening towards the back so you can access the USB port. I installed a Beecore V2.0 and an fx805 camera VTX combo that I had lying around. I made my own connector out of balance plugs but they only have 2 pins (solid pins) which result in less voltage sag. I have included a picture of the size difference between a ph2.0 connector and mine. Since 3d printing has its limitations printing columns that are hollow is very difficult, the Beecore needs to be mounted with double-sided sticky tape on the square bit in the middle of the frame and the camera screwed down on top of that. I am using a 600 mAh battery with my custom plug mod to get around 3:30 - 4:00 min of flight time with plenty of power. I'm thinking of making a mount adapter for tiny whoop batteries (250 mah) and putting 2 of them in parallel, so let me know if you would like