Z-Endstop Reprap Neo

There is a revision of this Thing. The advantage is, you can adjust it from the front side. http://www.thingiverse.com/thing:987256

Inductiv endstop for German Reaprap Neo.
This part is an replacment for the original endstop. There is no need for any software update or additional hardware. All you need is:
- an Induktiv Sensor ( PNP Normaly open M8)
- a 3-pin Connector to connect it to the printrboard
- 2 Screws M3
- 2 nuts M3

1. Open the back side of the Printer
2. Unscrew the