Modular Rods for Rostock (100mm increments)

Modular Rostock delta push rods for a larger-than-standard Rostock build. I needed 300mm center-to-center but only had a 6" (150mm) print area to work with.

Each segment adds 100mm to the total rod length; you'll probably want to double-check the actual length, adjust, and re-tighten connecting screws for best results. I used M3x10, but M3x12 would have been better.

These _could_ be extended to 400mm or 500mm, but mine are already a bit more flexible than I'd like and will eventually be replaced with carbon fiber tubes & Traxxas 1942 ball connectors. Nevertheless, maybe someone will find this useful.

This design is a derivative of [Asger's half-rods](https://www.thingiverse.com/thing:34158), itself a derivative of a [half-rod design by sivar2311](https://www.thingiverse.com/thing:33673). The 'Mid' rod _should_ be fully compatible with either of those designs if you need to extend them to about 350mm.