8bitdo Micro Vertical Phone Mount / Case

This is a redo of my vertical phone mount for the 8bitdo Micro gamepad. Created this for a Samsung Galaxy S23 FE.

* The mount only touches the phone case allowing the controller to hover above the phone without touching the screen
* Switched to a 3 clip design for holding gamepad. It is a snug fit but I find if I start with the lower left corner and press in the top right corner it snaps in to place and holds strong.
* Changed the sides of the mount to only go partially down the phone. The rubber grip of my phone case is enough to hold on to the mount and makes it easier to attach the mount to the phone. Also makes it easier to modify to fit your phone.
* Include button clearance recesses to prevent accidental button presses while the gamepad is stored.
* Added stand alone cover with same recesses.

All models are already oriented for printing. If you are just printing the case supports are not needed. If you are printing the phone mount I used these settings for support to ha