Thingiverse
8mm Hole Sampler
von UserWL
0
Downloads
0
Likes
0
Makes
This is a basic hole sampler that is useful if your project uses an 8mm rod. Use this to check the expected versus real output of your 3D printer and if hole sizes can correctly fit the rod.
The hole on the rounded edge is 8.00mm. The next adjacent one is 0.10mm greater in diameter up to the last one being 8.40mm in diameter.
The hole on the rounded edge is 8.00mm. The next adjacent one is 0.10mm greater in diameter up to the last one being 8.40mm in diameter.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
