8x50mm Wall Plug

Hello, today I present to you this neat little plug. Features:Made to fit in 8 diameter holesNo extra support neededUnder 2.2g of filamentPrinted using 0.4mm Nozzle (The printed models in the picture was made using PETG but I am more than sure that it can be printed in regular PLA, I just don&#39;t have any at this moment to test that. Left is the V3 and right is V2) Settings:Initial Layer Height: 0.25 mmLayer Height: 0.25 mmInfill: 100% Size Changes:For Ø10mm Holes, Increase the model size in the slicer to 121.25%For Ø9mm Holes, Increase the model size in the slicer to 109.12%For Ø7mm Holes, decrease the model size in the slicer to 84.87%(Please note, The current model can not become any smaller than 84.87% due to the hook “support” becoming too small to print with a 0.4mm nozzle)If Any Flaws are found please post them in the comments so that I can improve the design <3 Edit Log:2024-07-30 Made the print 25% Cheaper and made the center hole wider on the inside.