Slicer Discord
8X8 WLED Matrix – 3D-printbaar model van MakerWorld MakerWorld
Electronics

8X8 WLED Matrix

542 Downloads
212 Likes
256 Makes
Model downloaden
A smaller version of a 32x32 matrix I created last year. The electronics require minimal soldering and NO programming skills. Everything can be done through the website. This uses WLED to run the matrix. The matrix can either be controlled using a ESP8266 or an ESP32. The parts I used can be found on both Amazon and AliExpress but I ordered them from AliExpress. This is designed specifically for:ESP8266 ESP8266 - AliExpress8X8 Matrix WS2812 LED 5050 RGB 8x8 LED Matrix - AliExpressYou will also require a USB Cable. The print consists of 4 parts. The case surround, diffuser, mid-plate and back. The mid plate is the only part that will need to be glued into place as long as your tolerances are good. The mid-plate holds both the Matrix and the ESP board in place.I have adjusted the print speed so that the flow is consistent throughout the print, this way you shouldn’t get any banding. This was printed in PLA with PETG as a support interface. If you don’t use a different filament as an inte
Categorie
Electronics
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gevorderd Lage betrouwbaarheid
Waarom?
4-delige montage
4 delen te monteren
Supports 1/3
Montage 2/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, PETG
Nabewerking
Lijmen
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie