Thingiverse
9.7inch iPad Pro Functional Stand
by KuniMita
2
Downloads
2
Likes
0
Makes
This is a stand that holds the screen keyboard of a iPad Pro 9.7 at a tap-friendly angle. Attach with spring-loaded pawls. And this has a mechanism to store the Apple Pencil and eject it by pressing a button.
Errors in the model would be resolved with automatic corrections. So, never mind.
## Print settings
Brims should be attached to prevent warping. It is also useful to make the print bed hot. I had set the bed temperature to 80 degrees Celsius with PLA material.
##Postprocessing
Remove the supports. There is no need to add support with a slicer. But, the support is hard-coded under the plate spring and in the groove of the arm.
Install the button.
Connect the arms with a 10 mm diameter spring or rubber band.
Errors in the model would be resolved with automatic corrections. So, never mind.
## Print settings
Brims should be attached to prevent warping. It is also useful to make the print bed hot. I had set the bed temperature to 80 degrees Celsius with PLA material.
##Postprocessing
Remove the supports. There is no need to add support with a slicer. But, the support is hard-coded under the plate spring and in the groove of the arm.
Install the button.
Connect the arms with a 10 mm diameter spring or rubber band.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
