Thingiverse
90 Deg. Off Set Bracket
von joebejm
9
Downloads
6
Likes
0
Makes
This is a 90 Deg. Off set Bracket That I made For my JGAurora A5S Printer. I don't have a space to locate my printer so I had to put in the corner but regular spool position was interfering with the wall. So This way I can push the printer closer to the corner.
I'm using my Spool Holder but original will work too. You Will need a M3 Screws and Nuts.
This is my Spool Holder
https://www.thingiverse.com/thing:4355471
I'm using my Spool Holder but original will work too. You Will need a M3 Screws and Nuts.
This is my Spool Holder
https://www.thingiverse.com/thing:4355471
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
