Slicer Discord
90 Degree Frame Bracket 2020 Extrusion – 3D-printbaar model van Thingiverse Thingiverse

90 Degree Frame Bracket 2020 Extrusion

123 Downloads
71 Likes
0 Makes
Model downloaden
I liked the original because it was much smaller than other versions but I wanted the ability to still mount plexiglass panels to it to make an enclosure. Also reduced the beveled portion inside the frame to reduce filament use while still sitting flush with the exterior face of the frame. The one with the bevel on the outside and the bevel removed from inside the frame with the nuts pressed into it will sit flush with the outside of the frame and allow the screws to pass through to the nut. This uses M4 nuts that will need to be press fit as they are tight.

Mounts to frame with M5x12 Button Head hex bolt & T-Nut.

Edit: Added some variants.
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

RichardCheesing publiceert ook op

13 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie