Lighthouse by Ashley Pavlovic

Lighthouse and side building, sat atop a rock. Complete with steps, walkway and tiny boat. Print with support as there is an overhang from the porch on the side building. I printed using white PLA on an Ultimaker2 using Cura's "High" quality setting. The Lighthouse (larger print in the image 8cm x 8cm 8cm) took 6 hours and 20 mins to print. The smaller in the image took 1 hour 15 mins.
This model was made in Morphi! http://www.morphiapp.com. In Morphi, people of all skill levels can make 3D pr