Thingiverse
92mm Ø cup holder
por Francois2025
0
Descargas
2
Likes
0
Makes
Cup holder for several cups. Ideal for Ø 90mm cups, possibly a little more but not much. Maybe would produce other diameters if needed, nothing sure yet.
Not tried, but should be printable without support if the sharp edge side is on the build tray, the whole design respects 45° rule and has only one bridge with 12mm radius.
Not tried, but should be printable without support if the sharp edge side is on the build tray, the whole design respects 45° rule and has only one bridge with 12mm radius.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
