Chuck_45mm_fullset

3 Jaw Chuck Full set with back plate 12mm threaded with both in and out jaw sets

infill = 100%
Layer height 0.2
Print Quality = high

You may need to clean or sand little bit gears etc. to make it perfect also its all depend on your 3D printer's setting
use grease to lubricate only after final test. Make sure all the parts are moving freely not jammed and not loose too.

Use Elan Key ranch 1/8" to loosen or tighten the jaws

You may need 6 screws 2mm x 10 mm long
I