Back
3DSEARCH / Printrbot Jr M8 Z-axis upgrade
Printrbot Jr M8 Z-axis upgrade – 3D printable model from Thingiverse Thingiverse

Printrbot Jr M8 Z-axis upgrade

by markbrannan
20 Downloads
10 Likes
1 Makes
Download Model
3d printer brass hack jr m8 metric printrbot rod upgrade Z-Axis
Replacing the stock 5/16" with an M8 threaded rod is easy, as the tolerances are lower than the difference in width between the two rods. However, when upgrading to an anti-backlash setup with two M8 nuts and a spring, this requires a hexagonal tube which captures both nuts.
Source
Thingiverse
Comments
0

Comments

No comments yet – be the first!
All Thingiverse Models More by markbrannan

Similar Models

6 Suggestions
Prusa i3 X End Motor for leadscrews
Prusa i3 X End Motor for leadscrews
by hackermagnet
↓ 130 ♥ 84
DIY Bike Stereo System with 20W Speaker
DIY Bike Stereo System with 20W Speaker
by adafruit
↓ 87 ♥ 99
BRASS BIRMINGHAM INSERTS / INTERNAL ORGANIZER BY AM-MEDIA [MULTICOLOR WITH ANY 3D PRINTER]
BRASS BIRMINGHAM INSERTS / INTERNAL ORGANIZER BY AM-MEDIA [MULTICOLOR WITH ANY 3D PRINTER]
by ammedia3d
♥ 1
Z-Axis Holder for Flanged M8 Brass Nut -Scalar S 3D Printer Upgrade
Z-Axis Holder for Flanged M8 Brass Nut -Scalar S 3D Printer Upgrade
by JMcAz7
↓ 27 ♥ 37
BRASS BIRMINGHAM INSERTS / INTERNAL ORGANIZER BY AM-MEDIA [MULTICOLOR WITH ANY 3D PRINTER]
BRASS BIRMINGHAM INSERTS / INTERNAL ORGANIZER BY AM-MEDIA [MULTICOLOR WITH ANY 3D PRINTER]
by ammedia3d
♥ 7
The J-Head Lite V2 Ultimate Economy RepRap 3D Printer Hot End
The J-Head Lite V2 Ultimate Economy RepRap 3D Printer Hot End
by ohioplastics
↓ 49 ♥ 47

Add to Collection