Thingiverse
9600 Baud Modem Doorstop
von hoco
0
Downloads
0
Likes
0
Makes
KerrrrrrrrrrSheeeeeeeeePawwwwwwwwwwwGrrrrrdlrdlrdlrdlrrrrWeeeAhhhWeeeeeeeeeePink! Connect your door to the floor!
This print takes 3 hours and 27 minutes on my MKS3+, which is the same length of time it would take to download a 14.25 MB file over a 9600 baud modem. That is roughly 14 minutes of MP3 audio or a bit less than a minute of 1080p MP4 video.
If you have a bigger gap under your door you could either glue a sheet of rubber or felt underneath (also reduces slipping), or expand the print in the Z direction in the slicer.
I used variable layer heights, reducing the layer height at the top and bottom of the print to the minimum for a little smoother curve in the flattest parts.
Printed with Eryone Tricolor Silk Filament (black, purple & blue) using the Spool Rotator (https://www.thingiverse.com/thing:6114566)
This print takes 3 hours and 27 minutes on my MKS3+, which is the same length of time it would take to download a 14.25 MB file over a 9600 baud modem. That is roughly 14 minutes of MP3 audio or a bit less than a minute of 1080p MP4 video.
If you have a bigger gap under your door you could either glue a sheet of rubber or felt underneath (also reduces slipping), or expand the print in the Z direction in the slicer.
I used variable layer heights, reducing the layer height at the top and bottom of the print to the minimum for a little smoother curve in the flattest parts.
Printed with Eryone Tricolor Silk Filament (black, purple & blue) using the Spool Rotator (https://www.thingiverse.com/thing:6114566)
hoco veröffentlicht auch auf
121 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
