Filament and Cable Guide Add-on Sleeve Flashforge Creator / Pro

This is an add-on to http://www.thingiverse.com/thing:735350. It's designed to hold split loom (1/2" or stock Flashforge) covered wiring. I did not use the small filler piece from the original design base. The hole for the mounting screw closest to the sleeve will need to be countersunk enough to allow the screw to sit flush. I used a hand held drill bit (no drill motor) so I wouldn't over drill it.

I like using clear 6mm PTFE tubing with the Macroline fittings as it allows a visual status o