Thingiverse
'97-'06 Jeep TJ Automatic Shift Indicator Lower Bracket
by dusin1
69
Downloads
32
Likes
0
Makes
This is a replacement for the bottom of the Indicator Assembly on a TJ Jeep Wrangler with an automatic.
The finished part should measure 5.100" L x 3.615" W and 1.818" Tall
The holes that are molded in the top cover bosses are too large for the #6 screws as molded. Fill these bosses with epoxy, let cure & drill them out with a 1/8" bit. After which you can mount this printed bottom to the top bezel with #6 x 1/2" thread forming screws.
Note: if your bottom posts broke off inside the bosses like mine did, you may have to drill out the broken bottom posts that are left inside the bosses first, then fill bosses with epoxy.
The finished part should measure 5.100" L x 3.615" W and 1.818" Tall
The holes that are molded in the top cover bosses are too large for the #6 screws as molded. Fill these bosses with epoxy, let cure & drill them out with a 1/8" bit. After which you can mount this printed bottom to the top bezel with #6 x 1/2" thread forming screws.
Note: if your bottom posts broke off inside the bosses like mine did, you may have to drill out the broken bottom posts that are left inside the bosses first, then fill bosses with epoxy.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
