MakerGear M2 LocLine Raspberry Pi Camera mount for OctoPrint OctoPi or Astroprint

I'm using OctoPrint to run my MakerGear M2. I wanted to be able to mount the Pi in a position that gives a good view of the part so that I could remotely monitor it. The mounts that I found on Thingiverse were fairly large or tended to hold the camera in a bad position or both. This mount is very simple, just two small pieces so that it prints quickly and it works with readily available 1/4" LocLine (buy the genuine stuff, not the Asian ripoff). The Pi/Camera can be easily positioned in any