Da Vinci 3D Printer 1.1 Extruder MK8 modification

Da Vinci MK8 Extruder modification. This mod will allow you to print PLA and ABS without a problem. It uses the original extruder motor so you can run this using the original firmware.

Modification details:

1. Print the required 3 parts.
2. Remove the original extruder and motor.
3. Insert the rubber filament into the provided hole in the ex holder.
4. You will need to cut down the smaller of the filament tubes to it fits a little.
5. Reverse the extrude motor wires. This is re