Thingiverse
Warp test for PET and PETG filament
by thingyuser
40
Downloads
17
Likes
0
Makes
Because of the very low warpage of PET and PETG filament, this print is designed to warp very easily so the printer can be tested. In particular:
1. The base is very thin, so it can flex upwards at the ends easily.
2. The design is long, giving lots of room for warp to occur.
3. The pointy ends provide almost no attachment to the bed, yet easily show any warpage upwards.
4. The bottom corners are square (the worst kind for warps).
5. The tall rails give lots of leverage for the
1. The base is very thin, so it can flex upwards at the ends easily.
2. The design is long, giving lots of room for warp to occur.
3. The pointy ends provide almost no attachment to the bed, yet easily show any warpage upwards.
4. The bottom corners are square (the worst kind for warps).
5. The tall rails give lots of leverage for the
Sign in to leave a comment
Sign in