Thingiverse
RAMPS 60mm Fan Holder (Angled)
by EOD
16
Downloads
8
Likes
0
Makes
Remixed from the 60mm fan holder...
This one I angled out and elongated a bit in order to get a wider "bite" on the RAMPS board and allow for some room underneath.
Best if combined with some lifter-style legs for the Robo3D otherwise might not allow enough room with stock height.
These are a good recommendation:
http://www.thingiverse.com/thing:681876
This one I angled out and elongated a bit in order to get a wider "bite" on the RAMPS board and allow for some room underneath.
Best if combined with some lifter-style legs for the Robo3D otherwise might not allow enough room with stock height.
These are a good recommendation:
http://www.thingiverse.com/thing:681876
Sign in to leave a comment
Sign in