9mm Ammo Case

The Print files, “9mm lid and “9mm case will ONLY fit rounds that are at or less than 1.1 inches. (Hollow points some ball ammunition) The two print files “9mm Top 1.169 Max” and “9mm Case 1.169 Max” should allow ANY standered 9mm round to fit without lid clearance issues. If your rounds are longer than 1.169 inches you probably have bigger issues than them not fitting in this case. Print files can be printed on the same plate but if you are having surface quality issues I suggest printing separately. Magnets (8x2mm) can be incorporated into the lid and case during printing. They give a satisfying "click" when the box is slid shut and do a good job keeping it closed. When the lid is removed it is inserted into the slot in the base of the case to push the rounds up for access. My print settings: (Your mileage may vary) 0 .4mm nozzle0.12 layer thicknessMatte PLA Print both the case and lid vertically, no supports should be required. I suggest disabling “slow down for overhangs” s